To run a single route, you must specify each location where a change of railroads (or railroad families) occurs. In the example shown below, a warning is ge...

The stop list in a single route or AutoRouter window can be edited using the right mouse menu off any stop on the list. To open the right mouse menu, right ...

The width of individual columns in a single route window can be adjusted—place the cursor over a column divider so that it becomes a horizontal arrow, then ...

TIP: Always check first that the format selected in the format drop-down matches your input. Error Message Description NO MATCHES FOUND No matches were...

If you are experiencing recurring errors during route entry because the station or railroad you attempted to enter can’t be found in the PC*MILER|Rail datab...